cmon4day

Forum Replies Created

Viewing 15 posts - 4,861 through 4,875 (of 5,041 total)
  • Author
    Posts
  • in reply to: New Cell Service #366
    Anonymous
    Inactive

    I talked to customer service at Wilson and they recommend an amp and pre- amp.

    In all about 600 bucks from amazon.

    in reply to: air quality #496
    Anonymous
    Inactive

    Late evenings and mornings are poor, but afternoons and early evening are just fine, Kayaked up at Utica and elephant rock this afternoon, beautiful; no at Elephant rock but us.

    in reply to: Water pressure #508
    Anonymous
    Inactive
    Quote:
    thanks. i only have 1 ball valve that i operate when i winterize the house. pretty easy to tell when its open.  i've winterized the house probably 15 times and this condition has always been the same.  i don't know where a pressure regulator would be. all i have found is the actual meter itself down by the street.  does that mean there will be something else that is going to be buried somewhere that i will have to dig up?

    I'm pretty sure your regulator would be in the "basement" part of your place. Our place has two valves plus a regulator. One valve is near the main water valve and the other is under the main floor of the cabin, and the regulator is there too. It will likely look "similar" to the attached photo. I'm sure your cabin was built after ours and ours has copper pipe and some kind of flexible plastic or rubber main (not PVC), so it's very doubtful you have any galvanized pipe.

    in reply to: air quality #495
    Anonymous
    Inactive

    [youtube]http://www.youtube.com/watch?v=_21i4N4Euqg[/youtube]

    in reply to: Water pressure #507
    Anonymous
    Inactive

    The PRV at my house is located just on my side of the water meter and is within the meter box. I had it replaced a few years ago and there was an improvement in pressure.

    in reply to: air quality #494
    bigtreestechman
    Keymaster

    I drove up to Lake Alpine this morning.  At about 8AM it was pretty smokey here in Dorrington and quite a bit thicker up there.  I suspect it will clear some in the afternoon.

    in reply to: air quality #493
    Anonymous
    Inactive

    These updates on the air quality are great. Please keep them coming.

    in reply to: Water pressure #506
    Anonymous
    Inactive

    I wonder if you have galvanized pipes? pressure and flow are both required, not pressure alone. 60psi is the same in a 1/2" pipe or 3/4" pipe. But flow is very different. Old galvanized pipes will have pressure but not allow much water to flow.

    in reply to: Water pressure #505
    Anonymous
    Inactive

    thanks. i only have 1 ball valve that i operate when i winterize the house. pretty easy to tell when its open.  i've winterized the house probably 15 times and this condition has always been the same.  i don't know where a pressure regulator would be. all i have found is the actual meter itself down by the street.  does that mean there will be something else that is going to be buried somewhere that i will have to dig up?

    in reply to: Bear at Moose Lodge last night! #442
    Anonymous
    Inactive

    Love the Moose Lodge bear!!
    LostBruce-what kind of camera do you have? I would love to see who visits us!  :D

    in reply to: Bear at Moose Lodge last night! #441
    Anonymous
    Inactive

    caught a bear on our "tree" camera a few weeks ago too. can't seem to figure out how to post a picture. pretty cool to check the pictures on the camera and see a bear. Usually just deer, squirrels, occasional coyote and fox. still waiting for a mountain lion to wander by someday.

    in reply to: Water pressure #504
    Anonymous
    Inactive

    Water pressure varies quite a bit in BTV depending on where you live. The higher the elevation, the lower the pressure. However, I would agree with joe. Check the regulator first.

    Our water comes from the same place as fire hydrants. CCWD came by one day and checked the water pressure at the hydrant. It was about 60 pounds. A friend "down" the street has about 90 pounds before the regulator. Last time I checked my water pressure (several years ago) after the regulator it was about 45 pounds. Regulators are adjustable but make sure they aren't leaking.

    in reply to: Water pressure #503
    Anonymous
    Inactive

    CCWD recommends a pressure reducer as close to the street on/off valve as possible.  That is where mine is located.  I agree with the others above, check all the valves starting at the street. I'm sure you will find it.

    If not, ask one of your neighbors if you can check their water pressure for comparison.  If they have the same issue, maybe a call to CCWD is in order.

    Carl

    in reply to: air quality #492
    Anonymous
    Inactive

    [youtube]http://www.youtube.com/watch?v=7O_WvrJn2Hk#action=share[/youtube]

    in reply to: Water pressure #502
    bigtreestechman
    Keymaster

    A while back I discovered that the previous owner had turned down the pressure regulator.  I turned it up a bit to what felt like "normal".  Only guess as to why he did it was to lower the risk of pipes bursting but only guessing.
    Our regulator was next to a shutoff valve that we have near the house, not the one at the street.

Viewing 15 posts - 4,861 through 4,875 (of 5,041 total)